根据筒体扫描温度判断喷煤管的位置(国外英语资料).docVIP

根据筒体扫描温度判断喷煤管的位置(国外英语资料) Determine the location of the coal injection pipe according to the scanning temperature of the cylinder Our 2000t/d precalciner kiln is equipped with a cylinder scanning device to observe the cylinder temperature. After several years of trial and error, our experience is from The cylinder body temperature reflected by the barrel scanning can help to see the fire work more intuitively and accurately. 1 normal production time 1.1, the location of the coal injection pipe is moderate, from the cylinder scanning, from the kiln head to the firing tube The body temperature is evenly distributed at about 250~300 degrees. The temperature of the transition zone cylinder is about 350~370 degrees, and the zone is burnt The length of the solid kiln cover is 40% of the length of the kiln, and the transition zone has no lower cylinder temperature (i.e. no cold ring) The location of the coal pipe is right. At this time, the flame shape is smooth and powerful, and the decomposing kiln is in the best calcination state and the firing zone The shape of the kiln skin is flat, the thickness is moderate, the particle of the clinker is even, and the quality is good. 1.2 the location of the coal injection pipe is far from the material and lower When the barrel scanning shows the temperature of the kiln head is high, the temperature of the burning tube body decreases gradually, and looks like the horn shape, It shows that the location of the coal injection pipe is far away from the kiln, and it is partial to the bottom, so that the kiln head and kiln shell are thin and burnt, and the kiln skin is becoming thicker and thicker. At this point the clinker particles are small, no large pieces. But fCaO in the clinker kiln raw material is easy, many. The coal injection pipe should be slightly attached and raised slightly. There is also another case where the location of the coal injection pipe is suitable at this time, But the wind, coal and material have changed, and the