CAD实训小结(国外英语资料).doc

CAD实训小结 During the sixteenth week of 2007, under the guidance of the teacher Yang Zhiqin, our class had a week of concentrated CAD drawing training, mainly for several shaft, box type and fork type common parts of the drawing, through training, to further understand the application of CAD in Cao, enhance the ability of. Time flies, and to todays deadline, a week of CAD mapping training is coming to an end, and now recall just entered the computer room that ignorant, and they all feel funny. After a semester of study, in the face of a larger amount of graphics, I do not know where to start. Class is a step by step, one by one command of learning, after-school practice also does not involve knowledge before and after, the continuity of knowledge is not large, when we practice the use of, before the discovery of learning a little strange. The first day of training, the teacher will give us the first arrangement this week training course, explains the main contents of this week of training, training objective and significance, and then explain the details of the problems, some places that should be paid attention to, and examination system. After listening to the teachers explanation, I did not immediately go to the drawing, but with two classes carefully to see the task instruction and design guide book, very carefully read the drawing requirements, and prompt steps, which can reasonably accomplish this weeks training work, I have a positive attitude to face this rare opportunity of training. The training schedule was a little tight, especially on Wednesday, from 12:00 noon to 17:00 p.m., after seeing such a schedule, there was no urge to sneak away. Then Ill take a closer look at the Cao of each map for details, some hints, and some others. I want to combine what I have learned with the help of my teachers and classmates. I think this weeks training will be a great success. In the next few days, I have been conscientiously to draw every map, over every detail, drawin