MIDAS软件常见提问与解答(国外英语资料).docVIP

MIDAS软件常见提问与解答 Common questions and answers for MIDAS software Font: | small print published: 2006-12-08 17:36 Author: mufasa_zzh source: CAD architecture review Because the word limit can only send attachments, need friends can, remind, may buckle gold coins, I also dont understand. Ha-ha Common questions and answers for MIDAS software Part I. partial instructions 1. define the steps of moving loads In the main menu, load moving load analysis data vehicle, select standard vehicle or custom vehicle. For the moving load of the population, the lane load in the vehicle type defined in the user-defined manner is defined as line load (e.g., load 0.5tonf/m**2 in the norm multiplied by lane width 3M, input 1.5tonf/m). When defining the moving load of a population, be sure to enter Qm and Qq, and enter the same value. Concentrated load input 0. Layout of lane or lane (beam element model selection, definition of lane, plate element model selection, definition of lane surface), pedestrian walk of population load should also be defined as a lane or lane surface. Defining vehicle groups. This option is used only in special circumstances where different lanes allow loading of different vehicle loads. Definition of moving load cases. For example, the lane load can be defined as the condition -1, and the vehicle load is defined as the working condition -2. In the case of sub loading that defines the moving load case dialog box, the lane to which each vehicle is to be loaded is defined. For example: the user defined 8 lane, of which 4 were left, 4 right partial load partial load, the definition of two sub load, and choose alone, said separately calculated the maximum program automatically find. In the definition of sub load, if the minimum number of lanes can be loaded and the largest number of lanes can be loaded in the input 1 and 4 respectively, said 1, 2, 3 respectively, 4 horizontal layout of the vehicle (15 cases). When choosing a lane, the vehicle cannot include the pedest