修理电视机线路板大揭秘(国外英语资料).doc

修理电视机线路板大揭秘 To repair an ordinary 14-34 inch circuit board, be sure to adjust the field amplitude to the following side Method: The circuit board has output capacitor negative output capacitor series resistance 1.5 ohm resistance can be reduced to the formation of a sawtooth wave for +25V-30V power supply of ordinary OTL, without diminishing the field amplitude and some models have no character. For the + 13V supply (including pump circuit +40V power supply field block) OCL (no output capacitor) field output circuit, output of the deflection field 1 ohm sawtooth wave forming resistance, series 1.5 resistor can make a decrease, if not reduce the field amplitude and some models without character. The power supplied by the +16V and pump circuit +40V power supply BTL dual output field block, due to the double end + sawtooth wave input, the change can change between + sawtooth wave amplitude, the specific method is between two input a 10K potentiometer to change the amplitude of the output field. The level of resistance to deflection coil by field output circuit of discrete components, in order to adapt to the tube deflection circuit enables imaging deflection coil to change the switch resistance level, with high switch resistance, specifically how to change the logical thinking can be successful. Two for PHILPS circuit board normal operation, 14 inch picture tube error protection PHILPS circuit board has complete and rigorous protection circuit, one of which is the pulse rectifier filter access filament, mainly by PNP tube filament voltage loss protection circuit, as long as the received PNP emitter to filament rectifier filter, the resistance of the two resistor divider, a corresponding decrease times (increasing emitter voltage) you will not miss the protection, the above method is valuable to determine their own according to models. Three attention to all kinds of high-definition TV circuit board Circuit reference The excitation pulse normal in 14 inch picture tube