全国电子设计大赛试题(国外英语资料).doc

全国电子设计大赛试题 2009 National Undergraduate Electronic Design Competition A title -- photovoltaic grid connected power generation simulator B - sound guidance system C -- Broadband direct current amplifier D title -- wireless environment monitoring and simulation device E title -- electric energy collection charger F title -- digital amplitude frequency equalizing power amplifier G title - low frequency power amplifier H Title --LED dot matrix writing display screen I title -- simulated street lamp control system 2007 National Undergraduate Electronic Design Competition Audio signal analyzer (A title) [undergraduate group] I. task Design and manufacture an instrument that analyzes the frequency components of an audio signal and can measure the distortion of a sinusoidal signal. Two, requirements 1. basic requirements (1) input impedance: 50 ohms (2) input signal voltage range (peak to peak): 100mV to 5V; (3) the input signal contains frequency components ranging from 200Hz to 10kHz (4) frequency resolution: 100Hz (can correctly measure the measured signal, frequency difference is not less than 100Hz frequency components of the power value) (5) the detection frequency and the input signal power and the total power of each frequency component of each frequency component of the detected power and not less than 95% of the total power value; absolute value of relative error of each frequency component of the power measurement is less than 10%, the absolute value of relative error is less than 5% of the total power measurement. (6) analysis time: 5 seconds. In 5 seconds refresh cycle analysis data, signal of each frequency component according to the power sequence storing and playback display, real-time display and the total power of signal and at least two frequency components of the frequency value and power value, and keep the data displayed on the pause button. 2. play part (1) enlarge the dynamic range of input signal and increase sensitivity. (2) the input signal contain