好神拖维修(国外英语资料).docVIP

好神拖维修 I. maintenance methods 1, for imitation goods, if the following problems arise: A, after stepping on the pedal, turn the bucket aside, but the pedal does not return. The most common problems that may occur easily, accessories are spring tension, or gear friction is too large, dead locking clip. Can be purchased with a matching spring to be replaced, the replacement method is as follows: The first step: first use the cross screwdriver to remove the foot pedal, and then use the M4-M5 six angle button to remove the big red gear. The second step: remove the ruler bar, remove the damaged spring, and install the new spring on the bayonet of the foot bar. The third step: the rule of the new installation, the other end of the spring with pointed nose pliers or other tools to install another bayonet on the foot pedal. The fourth step: install the big gear, and finally install the whole foot pedal. Answer: replace the spring, pinion. B, after stepping on the pedal, turn the bucket and turn back again. This problem often occurs, one-way small bearings have been damaged, has been slippery silk, need to replace the matching bearings, can be solved. C, after stepping on the foot pedal, the bucket is swung and turned back again, and the foot pedal does not return to position and slips Answer: replace the pinion. Phone this information from the people network One, good God, easy to drag the problem Imitation good God drag, because quality does not pass, lead to frequent problems, summarized as follows: 1, spring. Because the material manufacturing imitation spring towing is low type ordinary steel, fine spring body, to guide in moist environment, often rust, easily broken, after a period of time, resulting in insufficient pedal spring, not very good return. The spring is made of high quality stainless steel, and the spring body is strong and will not rust, but there will be very other, in case of excessive force, it will cause the spring to be broken. 2, ruler