安全工作守则(国外英语资料).docVIP

安全工作守则 (1) inspection of substation equipment (four, six steps, seven bans) four 1., there must be approved patrol work instruction (card). 2., there must be patrol route identification. 3. to have good ventilation equipment, lighting equipment. 4., there must be qualified and complete labor protection equipment and safety equipment. Six steps 1., clear the purpose and tasks of inspection. 2., carry out risk analysis, develop risk control measures. 3. norms wear labor protection products. 4. patrol in accordance with the inspection path and inspection card. 5., do a good job patrol record and signature in place. 6. record the result of patrol and report the situation as required. Seven prohibition 1., no other work during the single tour, remove or cross the barrier. 2., do not keep adequate safety distance with the equipment. 3., strictly prohibit the thunderstorm weather patrol outdoor high voltage equipment, not wear insulation boots or near lightning arrester, lightning rod. 4., strictly prohibit the grounding of high voltage equipment, not wearing insulation boots, indoor close to the fault point within 4 meters, the outdoor approach to the fault point within 8 meters. 5., no access to the fully ventilated and qualified SF6 switchgear room. 6., do not carry wireless communication tools that are not closed. 7., strictly prohibit the inspection of high-voltage distribution room, did not close the door. (two) switching operation (six to eight steps, ten bans); Six, he said 1., there should be obvious device name identification. 2., there should be a system simulation diagram which is consistent with the on-site primary equipment and the actual operation mode. 3., there must be on-site operation regulations, typical operation tickets and unified dispatching operation terminology. 4., there must be accurate operation instructions and qualified operation tickets. 5., there must be qualified and complete labor protection products, safety tools and safety facilities.