控制器说明书(国外英语资料).doc

控制器说明书 (1) the state of the controller; FT - 3 controller through different operations, will make the controller in different state, according to the display value of different points, divided into the following states. 1, EA status: the display shows EA, this state is that the controller has just turned on the power supply, or in any other state, press reset, or after the whole machine has been cleared, the controller is in a starting state. 2, the Eb status display: Eb, this is the state controller in the EA state, according to the function, the state controller; in the Eb state, combined with some other keys, waiting for the controller input some parameters. 3, nEA status: the monitor shows nEA, this state is the controller in the EA state, press the numeric keys 0 ~ 9 after the control of the state. In the nEA state, the controller is waiting for input, modify, and query programs. 4. Processing status: by default, the display displays the remaining J value of the processing program. It is a constantly changing number, when the controller is executing the processing program. (two) the function of each key in EA state 0 ~ 9: program number, display nEA (n as the starting line, the following are representative of a n program, and the n is less than or equal to 800; Display X: displays the X coordinate value of the destination; Display Y: displays the Y coordinate value of the destination; Significant J/ rotation: shows the angle of rotation value; Significant Z/ compensation: display compensation amount; Delete / clean angle: show clear angle; Online / symmetric: display symmetry (0 indicates no symmetry, and said X Y said axial symmetry, symmetry axis Y); Insert / rotate: display auto rotation angle value; Increments / cycles: shows the amount of loop (the highest two bits indicate the number of loops, and the last two represents the number of cycles); GY-/ inverted cut: display - 000EA, and then enter n, which means from the N program to cut back; Feed /L3: feed