放电管2(国外英语资料).doc

放电管2 N The circuit on the circuit board and the external connection may be added, such as: work power input loop, analog signal, signal input and output loop. Equivalent to the lightning arrester integrated into the board. Main specifications / special functions: Product brief: A gas discharge tube is a switching device in which the voltage is switched on. It is used in parallel between the line and the line or the line and the ground of the protected device (as shown below). When the external voltage surge has not reached its operating voltage, the discharge tube is in a high impedance (insulation resistance of 1000M ohms above), and once the surge voltage reaches its operating voltage, discharge discharge gap breakdown occurs immediately, the discharge tube is equivalent to a good conductor, the surge voltage is rapidly shorted to near zero the voltage at 50ns time, surge current was quickly into the ground, thus to protect the equipment. When the surge voltage disappears, the GDT will extinguish and return to a high impedance state, waiting for the next action. I. protection principle Under normal circumstances, the discharge tube due to its high impedance (more than 1000M) and low capacitance (10pF) characteristics in it as a protective element access line when the normal work of the line almost without any adverse effects. When the harmful transient voltage into the discharge tube, the first is the breakdown discharge, the impedance decreased rapidly, almost a short circuit state, at this time, the discharge tube will be harmful to the current through the wire discharge to the earth at the same time, the voltage limit in the discharge tube on the arc (around 20V), eliminating the harmful transient overvoltage and overcurrent, thereby protecting the circuit and components. When the over-voltage disappear after the discharge tube and quickly return to a high impedance state, the line continues to work. Two 、 application field (1) as protective devices; If your li