水泥仪器操作规程(国外英语资料).docVIP

水泥仪器操作规程 Operation regulation of cement paste mixer First, the use of operation 1, the power cord into the socket, red light on the power supply. Turn the torque switch to the automatic position, press the small button switch, then automatically complete a slow turn --- stop --- fast turn program. 2, if you place a twist on the manual position, then manual three bit switch to complete the action. If the handle is left and right, the handle can drive the stirring pan to move up and down along the dovetail guide rail of the upright column, move upwards, be used for stirring, and move downward to remove the stirring pot, and the stirring pan and the slide plate are rotated and locked by an eccentric groove. Two, matters needing attention 1. The working gap between mixing blade and stirring pot should be 2 + 1mm. 2, each time after use, should thoroughly remove mixing blade and mixing pot inside and outside residual paste, and clean scattered and flying in and on the mortar and stay in, dry, put on the shield, placed in the dust. 3, when the machine running, such as metal impact noise, should check the mixing blade and mixing pot gap is correct. 4, the use of mixing pot should be gently handle, not arbitrarily fall touch, in case the pot deformation. Operating rules for boiling boils First, the use of operation 1. Add water into the boiling pot to the required water level. Plug the four core into the socket on the program controller. 2. Turn on the power and the indicator light is on. 3, the machine set the signal program work, press the work button, the instrument began to heat up. 4, after the completion of the test, the instrument stopped working, turn off the power switch, about 5 minutes after the release of water, open the box cover, cool down to room temperature, take out the sample, the box after the evaporation of natural water, and then cover the lid. Two, matters needing attention 1. The water injection in the tank is usually 180mm, and the instrument should