美能达故障代码清单(国外英语资料).docVIP

美能达故障代码清单 Fault code, fault name, detection opportunity C0000 main motor fault When the main motor starts running, the lock on the main motor (M1) will continue for 1 seconds at any time after 1 seconds (HIGH). C0044ADF cooling fan fault (only when installing optional AFR-19) For details, please refer to the purchase and maintenance manual (AFR-19). C0045 fixing cooling fan motor failure During the full speed or deceleration operation of the fixing cooling fan motor, the lock cooling fan motor (M3) lock signal will maintain a high level for 1 seconds for consecutive periods (HIGH). C004E cooling fan motor failure ? maintained at ON in remote signal power cooling fan motor (that full speed turn) or OFF (slow rotation period, said) power supply cooling fan motor (M4) locked signal will maintain a high level for 1 seconds (HIGH). C0070 main powder motor failure During the period when the toner bottle is rotating, the toner bottle in situ sensor (PC7) will output high level (HIGH) signals for 3.5 consecutive seconds. When the toner bottle is turning, the carbon bottle in situ sensor (PC7) will continue Output low level (LOW) signal for 2 seconds. Abnormal transfer voltage of C0210 image When the PC photosensitive drum remains stationary, the image transfer voltage is maintained over 100 V for a specified period of time. The C03FF mode is not set properly. The mode Settings Settings in the maintenance mode are not set correctly. C0500 preheat fault During the preheating cycle, the surface temperature of the fuser roller has not reached the required level after the prescribed time. 35 seconds from room temperature to 100C: From 100C to 140C: for 25 seconds From 140C to complete preheat cycle: 20 seconds C0500 Preheat faults (for models with two fixing rollers, heating lamps) * limited to Di2011 30 seconds after the start of the preheating cycle, the fixing roller thermistor does not detect a predetermined temperature and thus does not complete the preheating cycle. During