2510 2510 (英文说明书).pdf

ientsw d MODEL 2510 2510 ECONOMINDER Service Manual IMPORTANT: Fill in pertinent information on page 2 for future reference. main head MODEL 2510 2510 ECONOMINDER job specification sheet • JOB NO. _________________________________________________________ • *MODEL NO. ______________________________________________________ • WATER TEST _____________________________________________________ • CAPACITY PER UNIT ____________ MAX. __________ PER REGENERATION • MINERAL TANK SIZE DIA. _______ HEIGHT_________ • BRINE TANK SIZE SALT SETTING PER REGENERATION: _________________________________________________________________ • * 2510 CONTROL VALVE SPECIFICATIONS: 1. Timer Program Used A. Separate Time Fill Cams B. Rapid Rinse Cams 2. Type of Meter (3/4”) A. *Std. range 125 to 2,100 gal. setting B. *Ext. range 625 to 10,500 gal. setting 3. Meter Gallon Setting ___________ gal. 4. Regeneration Program Setting (see page 6) A. Backwash ________________ min. B. Brine Slow Rinse _______________ min. C. Rapid Rinse _________________ min. D. Brine Tank Refill __________________ min. 5. Drain Line Flow Control _______________ gpm 6. Brine Refill Rate _______________ gpm 7. Injector Size___________________ Page 2 main head MODEL 2510 2510 ECONOMINDER sub- head installation instructions WATER PRESSURE: A minimum of 20 pounds of water pressure is required for regeneration valve to operate effectively. ELECTRICAL FACILITIES: An uninterrupted alternating current (A/C) supply is required. N