CISCO设备配置(国外英语资料).docVIP

CISCO设备配置(国外英语资料) C2950 # Config terminal goes into the global configuration mode Show interface thernet0/1 to view the configuration results of port 0/1 Show interface thernet0/1 status to view the status of port 0/1 Show MAC - address - table to view the entire MAC address table Clear mac-address-table restricted static clears the qualifying address C2950 (config) # Hostname 2950A/sets the host name 2950A Interface f0/23 / into port 23 configuration mode Enable password cisco/set enable password for cisco Enable secret cisco1 / set enable secret to cisco1 IP address / set the switch IP address IP default-gateway 54 / set the default gateway IP domain-name /set the domain name IP name-server / set the domain name server Configure to view the MAC address table MAC address - table? The MAC address - table aging - time 100 / setting timeout is 100s MAC - address - table permanent 0000.0 c01. Cc/f0/3 is added to the permanent address MAC - address - table restricted static 0000.0 c02. BBCC/f0/6 f0/7 to the static address The end Show MAC - address - table/view the entire MAC address table Clear MAC - address - table restricted static C2950 (config-if) # Interface: thernet0/1 / the interface F0/1 subconfiguration mode Interface Ethernet0 / into the ethernet-0 sub-configuration mode No shutdown/activation interface Speed? / see the child commands for the speed command Speed 100 / set the port rate to 100Mb/s Dulplex full/half/auto/set the port to full duplex The description TO_PC1 / set this port is described as TO_PC1 Show interface thernet 0/1 / view port 0/1 configuration results Show interface: thernet 0/1 status/view port 0/1 Configure VTP and STP One. Configure VTP 2950A # vlan database/enter the vlan configuration subpattern Show VTP status/view VTP Settings information Show vlan/view the vlan configuration information Copy running - config startup - config/save the configuration file 2950A (vlan) # VTP server/client/set this switch to server/client mode VTP pr