广数对刀(国外英语资料).docVIP

广数对刀(国外英语资料) One, 980T to the knife process 1, to the number 1 (set the 1st knife as the base knife), away from the workpiece to change the knife [program] -- the way of typing -- T0100 -- press [the] key -- then press [the loop start] button Ways of Z axis: [manual] - car Z axis end face, the X axis direction to exit the Z direction remains the same - [enter] way - G50 [enter] key - Z0.0 [enter] key - [] cycle start button again. Ways to X axis: [manual] - car X axis end face, the Z axis exit X direction is changeless, move to the safe place stop spindle, measuring diameter - [enter] - G50 [enter] key - X diameter value [enter] key - [] cycle start button again. 2, knife 2: [program] -t0200 - press [the input] key - then press [the loop start] button Way of Z axis: [manual] - point touch Z axis end face, namely stop, - [knife repairing] - [enter] - cursor check 102, - input Z0.0 press [enter]. Way to X axis: [manual] - point touch X axis end face, namely stop, - [knife repairing] - [enter] - cursor check 102, - input values, the X axis diameter press [enter]. The process of knife 3 and 4 is the same as the number 2, except to move the cursor to 103,104. 4, check if the knife is correct: [entry] -- T0202 -- press [the] button again Enter X30, Z0.0 - press the [input] key and press [loop start] Note: 1, in the case of a 2, 3, and 4, the input value must be added to the decimal point, such as measuring the diameter of the X, 28, but the input must be 28.0, otherwise the knife will fail. In the case of the screw, the X axis is the first, then the Z axis is pulled out, the X axis is 1 wire, and then the Z axis is more accurate. Do not use manual change after the knife, otherwise the knife fails, the knife repair is cleared. Fficeffice / Second, 980T break knife, reorder to knife and middle processing is the method. 1, again to knife: after grinding tool to install good, clear knife repairing the knife again, if as a benchmark cutter knife, in application to T0101 in [