扫描网络中已用的IP地址(国外英语资料).docVIP

扫描网络中已用的IP地址(国外英语资料) There are several ways we can help you scan the IP addresses you already use in your network. Method 1: the original ping method The first method is simpler and is more constrained by the environment. It is well known in did not install a firewall and set the filtering rules are allowed on the computer the ICMP protocol packets through, so we can use the command ping IP address to check if there is a computer USES the IP address. Enter the CMD and enter the command line mode via the start - run of the taskbar. Assuming the company network is 192.168.1.0/255.255.255.0, we can ping 192.168.1.1, ping 192.168.1.2... Ping 192.168.1.254 to test whether the IP address is occupied. Because the original ping method is simple, there is not detailed, but this method meets the computer installed on the firewall to filter the ICMP protocol, or the company on the switches and routers for ICMP ACL access control list filtering is not feasible. So by the limitations of this method is larger, general test success rate is not high, its easy to install the firewall of computer the IP address of the corresponding thought has not been used. Method two: scanner scanning Before the author in the network security work is often use the scanner to scan the network each host vulnerability, so now we can use this method to check what are the network IP address being used. Because the scanner scan is not just ping for the ICMP protocol, we can set up the scanner to scan multiple ports and scan several services. So even installed a firewall or switch on a computer with access control list to filter the ICMP protocol, as long as the computer open some port or service, you wont get omission. The list of IP addresses that are scanned by the scanner can also be exported as an HTML file or a TXT file, so that we can save and count. Of course, there are a lot of scanner tools, where you can use the x-scan and LANHELPER that youre interested in, and you can download it for yourse