电子线路总结(国外英语资料).docVIP

电子线路总结(国外英语资料) The pure single crystal semiconductor is also called the semiconductor, which has the same number of free electron holes in its internal carrier. 2, emitter follower is the common collector amplifier circuit, due to its voltage amplification digits is approximately equal to 1, and the output voltage phase with the input voltage, so it is also called a voltage follower (emitter follower). The ideal differential amplifier has a total mode voltage magnification of 0, and its common mode suppression ratio is equal to infinity. Normally, in analog appliances, transistors work in amplification state, and in digital appliances, transistor triode work is in saturated and cut-off condition. The limiting circuit is a waveform shaping circuit, which is divided into upper, lower, and bi-directional circuits because of the different parts of the waveform. The function of the main JK trigger is maintained, counted, set 0, set 1. The stage coupling of the multistage amplifier has the coupling, direct coupling, and transformer coupling. The series of voltage stabilizer with the amplifier circuit is grouped by adjusting circuit, reference circuit, sampling circuit and comparing amplifier circuit. The characteristic of the time sequence logic circuit is that the output state depends not only on the input state at the time, but also on the original state of the output. When the PN junction plus the reverse voltage, the space charge area will widen. The reverse current is formed by a small number of carriers. The semiconductor has unique characteristics such as heat sensitivity, photosensitivity, strength sensitivity and doping. Using the one-way conductivity of the diode, the alternating current can be turned into a pulsating direct current. The silicon stabilizer is normally working in reverse breakdown zone. In this area, the voltage of the silicon stabilizer is basically unchanged when the current of the silicon stabilizer is changed in a large scale. 14, capacitor