高速动平衡机1技术要求(国外英语资料).docVIP

高速动平衡机1技术要求(国外英语资料) High speed balancing machine 1 technical requirement Party a (buyer) : sany energy equipment co., LTD Party b (seller) : Party a shall purchase the high speed dynamic balance machine one (set) and the annex, party b shall be responsible for the installation and commissioning of the equipment, and shall be used by party a once the acceptance is qualified. The following technical requirements: First, the purpose of machine tool The principle of rigid supporting stiffness is used for the low speed and high speed of the flexible rotor in the tunnel vacuum explosion-proof chamber Speed balancing, working speed test and speed test. * low speed balance. * the rotor imbalance at work speed is measured at high speed. * flexible rotor deflection modification. * the testing of material strength under the effect of centrifugal force under the speed of the rotor. * running the test under the working support condition. All these tasks are performed under the same support condition of the rotor. The test artifact is simplified Second, quality requirements Party b to provide the equipment must be mature and reliable products, equipment, within the quality guarantee period for equipment design or production of bad and other supplier quality problems caused by the fault, the responsibility of the manufacturer immediately for free repair or replacement and debugging; Even if it exceeds the warranty period (within the lifetime of the device), if it is the quality issue of the devices nature, it is also required to repair or replace and debug it for free. The main technical parameters of the equipment (the important parameters of the area) The serial number parameter Specifications, parameters, one The maximum weight of the rotor rotor 8000 kg 2 The maximum length of the rotor rotor 6000 mm 3 The maximum diameter of the rotor rotor 1800 mm 4 The maximum distance between the shaft flange and the shaft flange 5000 mm 5 Maximum sensitivity 0.01 mm/s 6 It can achieve bal