TIA-568B光纤布线标准(外国英语资料).docVIP

TIA-568B光纤布线标准 TIA-568B.3 fiber optic cabling standard 4.3 physical characteristics of cables The fiber optic cable structure must be composed of 50/125, m or 62.5/125 multimode fiber or single-mode optical fiber, or assembled by them. According to the ANSI/TIA/EIA-598-A standard, single fiber and group optical fiber must be recognized. The cable must be listed in accordance with the electrical code and building code requirements and made detailed identification. Characteristics of 4.3.1 indoor fiber optic cable The mechanical and environmental characteristics of Indoor cables must be consistent with the ANSI/ICEA S-83-596 standard. 2 and 4 core optical fiber cables for horizontal or centralized wiring must support the bending radius of 25mm (1 inches) under no-load conditions. When the 2 and 4 core cables are installed to the horizontal line, the bending radius of 50mm (2 inches) must be supported at 222 Newton (50 lb) pull. In other indoor cables, the bending radius of 10 times the cable diameter must be supported when no tension is taken into consideration. The bending radius of the cable with 15 times of the cable diameter must be supported when the tension is considered. Characteristics of 4.3.2 outdoor optical fiber cable The mechanical and environmental characteristics of Indoor cables must be consistent with the ANSI/ICEA S-87-640 standard. The outdoor cables must be waterproof and conform to the standard ANSI/ICEA S-87-640 requirements for composite flow and fluid penetration. The minimum pulling force of an outdoor optical cable must be greater than 2670 Newton (600 pounds). When the outdoor cable does not take into account the tension, it must support the bending radius of 10 times the total diameter of the cable. When taking into account the tensile force (within the rated limit), the bending radius of 20 times the cable outer diameter must be supported. 4.3.2.1 cable The leading cable is a typical small caliber, low fiber number fiber cable, and can bea