轴承选择(外国英文资料).docVIP

轴承选择(国外英文资料) Page 1 The radial clearance is not adjustable after the wear of the sliding bearing. A (whole) B (dissection) The horizontal position of the split bearing, the oil tank on the shaft shall be open to ____. A (upper half axis) B (bottom half axis) C (the junction of the two-and-a-half axis) The bearing of medium speed, medium and high temperature is suitable to be used as the material of the shaft. A (cast bronze alloy) B (grey cast iron) C (bearing alloy) The basic principle of oil lubricants: heavy load, oil of choice of viscosity. A (large) B (small) Page 2 The basic principle of lubricants: the speed is high, the oil that USES viscosity ____. A (small) B (large) The basic principle of lubricants: low working temperature, the choice of oil of viscosity. A (small) B (large) The lubrication of oil to lubrication by oil pump through tubing is called ____ lubrication. A (spray) B (oil bath) C (soaked) D (oil spray) The lubrication of medium and low speed bearing is easy to lubricate. A (oil bath) B (oil spray) C (soaked). Page 3 The method of lubrication is suitable for bearings with high speed, large load and reliable lubrication. A (spray) B (oil bath) C (soaked) D (oil spray) It is suitable for lubrication of high speed and high temperature bearing parts. A (oil mist) B (oil) C (oil bath) D (soaking) E (splash) The type code for deep groove ball bearing is ____. A (6) B (1) C (2) D (5) Normally rolling bearing inner circle and shaft neck should adopt ____. A (tighter) B (looser) Page 4 The normal rolling bearing outer ring and supporting hole should be adopted. A (looser) B (tighter) In the rolling bearing assembly, the axial alignment and adjustment of the shaft are achieved by controlling the bearing ____. A (outer ring) B (inner circle) C (keeping frame) D (rolling body) In terms of economic considerations, it is necessary to choose the bearing when the requirements are met. A (ball) B (cylinder) C (conical roller) Bearing is used for supporting ___