冲孔桩偏孔改正办法(国外英文资料).doc

冲孔桩偏孔纠正措施(国外英文资料) An impact drill in Hunan karst area construction, pile diameter of 1400 27m deep hole, before a construction team in the exit card hammer and other factors after 18m drilling, the hole backfilled. After February, I took over the younger brother, before the technician did not tell me about the partial hole problem, only said the card hammer. I found in drilling to 16.5M has partial empty hole, the wire rope swing amplitude is very large, then throwing stones to rectify drilling hole, so repeated 7 days, drilled to 18.5 meters, although there is a single hole partial amplitude deviation has little to continue drilling to 20 meters from 18.5 meters to 20 meters long week, while drilling deviation, but the effect is getting worse, 20.4 meters of wire rope and orifice center deviation 30cm, there have been 90 cubic meters of rubble backfill, took 21 days. Again after 3 days, so repeated, still no effect. 21 meters to 24 meters, there is a layer of karst cave, must go through the cave to the cave, the bottom of the rock embedded more than 1.5 meters in order to end hole. Backfill, after natural dense (15 days) manual excavation treatment. Thank you. On the first floor, the site has previously had a hollowed out pile, which has been withdrawn from the site because of its abundant groundwater and pumping difficulties. The strength of backfill and the rock rubble should strength similar to it, according to your data, you may be the development of drilling in karst limestone strata, this is hard because of the difference, so easy to deflect, so we should pay attention to when the rubble backfill, preferably stone fill high strength. By way of rotary drilling hole, drill with rolling or ring cutting, design the drilling pressure and speed control, good footage, another two monitoring vertical direction, limestone formation is not a problem, but the cost is relatively high, tight for reference Thank you for giving me advice, 3 floor, block stone is the streng