吊篮脚手架(国外英文资料).docVIP

吊篮脚手架(国外英文资料) Nine, material hoist (Longmen rack, well rack) (1) frame making 1, should actively promote the use of construction departments identified or approved stereotypes products. Homemade material hoist must be approved by the competent department of construction drawings and identification, safety and quality assurance measures, should design calculations. The products manufactured by the manufacturer must be approved by the building safety supervision department before use. 2, material hoist should be suspended acceptance certificate, the largest lifting weight signs and safety warning signs. 3, construction site hoist should be safe and reliable, should use the steel frame, eliminate fastening type steel pipe well frame. (two) limit insurance device 1, material hoist must have broken rope protection device, safety stop device, upper limit device, more than 30M overhead hoist must also have lower limit device, buffer and overload limiter. 2, derrick rope breaking protection device should be used in rail clamping type safety stop device should be easy to use, and should be with the suspension cage safety door linkage, the upper and lower limit of the limit device should use mechanical type, the cage is process should be not less than 3M, all safety devices must be safe and reliable. 3, in order to facilitate the operation of the drivers position must be set up emergency power off switch, in case of emergency, should be able to promptly cut off the hoists total control power supply. When the power supply of the hoist is cut off, the working lighting should not be powered off. (three) stability of frame (1) cable wind rope; 1, the cable wind rope fixed frame, cable wind rope must be used. The diameter of more than 9 3mm Round strand wire rope, lifting frame body height below 20M when a group (four), 20 - 30M two. 2, the cable wind rope should be symmetrically arranged on the frame body four angle on the same horizontal plane, and the ground angle at 45 degrees