广数系统指令(国外英文资料).docVIP

广数系统指令(国外英文资料) Number system instruction 1: workpiece coordinate system setting (G50) instruction format: G50 X_Z_: in which X_Z_ is the starting point of the tool, relative to the origin of the workpiece X and Z coordinates, and X should be the diameter value. 2 workpiece coordinate system selection instruction (G54-59) instruction format: G54 (~G59) X_Z_: where X_Z_ is the coordinate value of the workpiece origin in the machine tool coordinate system. 3 rapid positioning command (G90 command format: G00 X (U) _Z (W) _: where X_Z_ is the target coordinate U_W_ absolute mode is under way under the coordinate increment of coordinate target. 4 linear interpolation (G01) instruction format: G01 X (U) _Z (W) _F- where X_Z_ is the absolute programming, the coordinate of the target in the build coordinate system, U-W- programming is incremental, incremental target coordinate, F- is the feed speed. 5, circular interpolation commands (G02, G03) instruction format: (G02, G03) X (U) _Z (W) _ (I-k-, R-) F- X_Z_ absolute programming, arc end point coordinates in the workpiece coordinate system; U-W- is incremental programming, the displacement of the circular arc end point relative to the starting point. I-K- is the center to increase the amount of arc starting point (equal to minus the starting point coordinates, coordinates the center of circular arc in the absolute, incremental programming is to incrementally instruction, in diameter, radius of programming I is the radius); R- is the radius of the circular arc, the arc center angle less than 180 degrees, R is positive, otherwise R F- is the feed rate is negative. 6, 1) and chamfer fillet chamfer instruction format: G01{X-K (C) Z-I (C) -}F-: where X-Z- is the location of the chamfered tip coordinate values: I (C, K) - (C) - if the chamfered tool chamfering value, along the axis is the direction of movement, and I K is positive, and negative values: F- is feed speed. 2) rounding instruction format: G01{X- K-}R (R) -F-; among