技术要求汇总(只做参考)(国外英文资料).docVIP

技术要求汇总(只做参考)(国外英文资料) Description: according to the actual production needs of their own modifications, trade-offs. (1) plastic parts; 1. before molding, the material should be preheated and dried. 2. after molding, the parts should be light and must not be deformed. 3. no fillet R0.5. 4., the outer surface should be smooth, and its roughness is not greater than Ra0.4. And may not scratch, scratch and other defects. 5. no injection tolerance shall be GB/T1804-92m class. (two) spring parts; 1. rotation: left hand. 2. total laps: no=12. 3. working cycles: no=10. 4. steel wire hardness: HRC42-48. 5. surface treatment: H.Y. (commonly known as blue). The 6. ends are tightly polished. (three) casting parts; 1. cold separation, cracks, shrinkage holes and penetrating defects and serious incomplete defects (such as casting, mechanical damage, etc.) are not allowed on the surface of castings. 2. castings should be clean, must not burr, flying, non machined surface of the pouring head should be cleaned, and the surface of the casting flush. 3. casting processing on the surface of the metal and non marking shall be legible, position and font should comply with the requirements of drawings. 4. sand casting castings, non machined surface roughness of Ra is not greater than 50 mu m. 5. castings should be removed from the riser, flying thorns and so on. The surface of the non - machined surface shall be flattened and polished to meet the surface quality requirements. 6. the molding sand, core sand and core shall be removed. 7. the casting has an inclined position, and the dimension tolerance and tolerance belt shall be symmetrically arranged along the inclined plane. 8. on the casting sand, sand core, core bone, fleshy, sticky sand should be grinding smooth, clean. 9., the wrong type, lug, casting bias should be amended to achieve smooth transition, to ensure the quality of appearance. 10. non machined surface wrinkle, the depth is less than 2mm, the spacing should be greater than