不锈钢波纹板冷弯成形有限元模拟研究.pdfVIP

36 1 2011 2 Vol36 No1 FORGING STAMPING TECHNOLOGY Feb. 2011 1 2 3 祎 , , ( 1. , 315 00; 2. , 271104; 3. , 130025) : MSCMarc, , , ; , : , , , : ; ; ; Marc DOI: 103969/jissn1000-3940201101036 + : TG3863 1 : A : 1000-3940 ( 2011) 01-0147-06 FEM simul tion of cold bending form tion l ws of st inless steel corrug ted pl te 1 2 3 ZHANG Yi , ZOU Zhong-ping , LIU Hu-min ( 1. Ningbo Xunhui Elect ric Appliance Co. , Ltd. , Ningbo 315 00, China; 2. Laiw u Iron and Steel Group Co. , Ltd. , Laiw u 271104, China; 3. Institut e of roll forging technology, Jilin University , Changchun 130025, China) Abstr ct: Using finite element softw are M SCMarc, the stainless steel corrugated plate cold bending forming process w as simulated and the cold bending forming finite element model w as established. The bit ing process w as analyzed and the bit ing w as realized through the method of the upper roll pressing . The variat ion of stress and strain of typical nodes w as simulated. The st ress-history curve and the transversal and longitudinal strain distribution curve of t ypical nodes w ere obtained. The results show that the deformation transition zone exists betw een the two f rames, and in where the plate has both elastic recovery and plastic deformat ion. Near the position of roll, the stress reaches the maximum, w hich is the main reason of the appearing defects. Keywords: cold roll forming; corrugat ed plate; numerical simulation;