太阳能发电硬件设计(国外英文资料).docVIP

太阳能发电硬件设计 In the design of PV system in addition to the battery capacity and the solar cell module size design, but also consider how to choose the appropriate equipment system, that is how to choose a system of solar battery assembly, battery, inverter needs (system with AC load), controller, cable, wire box, assembly bracket, diesel / gasoline engine (PV oil machine mixing system), wind generator (complementary system), power supply for large-scale solar photovoltaic station, including transmission and distribution engineering components such as transformers, lightning arrester, load switch, air circuit breaker, AC / DC power distribution cabinet, and system infrastructure, control room construction, transmission and distribution construction etc.. The selection of the above equipment needs to take into account the actual situation of the system, the size of the system, the requirements of customers and other factors. Solar modules, components, stents, batteries, inverters, and controllers are described in detail in other chapters of this book. Selection of 4.5.1. cables The following factors are considered in the selection of cables in the system: The insulation performance of the cable; The performance of heat resistant and flame retardant cable; U cable moistureproof, anti light; Cable laying; U type cable core (copper, aluminum); Size u cable. The connection between different components of a photovoltaic system is different because of the different environment and requirements. Technical requirements for different connections are listed below: 1) the connection between components and components The need for UL testing, heat resistance of 90 DEG C, anti acid, anti chemical, moisture-proof, anti exposure. 2) the connection between the interior of the square and the square Can be open-air or buried in the ground, requiring moisture, anti insolation. It is recommended that the pipe be fitted with a heat resistance of 90 degrees. 3) the connection between the accu