公路水泥稳定碎石基层振动试验法设计指南(外国英语资料).docVIP

公路水泥稳定碎石基层振动试验法设计指南 Guide for design of vibration test method for cement stabilized macadam base of highway 1 design content, design standards and design methods Design content: according to the strength index of cement stabilized macadam, the aggregate proportion and cement dosage are optimized, and the optimum water content and maximum dry density of cement stabilized macadam mixture are determined. The design standard of cement stabilized macadam base value R0.95 = 5.0MPa 7d soaking on behalf of unconfined compressive strength of cement stabilized macadam base; soaking 7d no value R0.95 is greater than or equal to 6.0MPa on behalf of unconfined compressive strength. Design method: vibration compaction test method is used to optimize aggregate gradation of cement stabilized macadam, determine maximum dry density and optimum moisture content, vibration compaction forming method, forming specimen, test 7d unconfined compressive strength. For vibration test, see Appendix A and appendix B. 2 aggregate gradation The aggregate of cement stabilized macadam shall be in accordance with table 1-1. Table 1-1 gradation of skeleton dense cement stabilized macadam (bottom) base course Through the following layer sieve size (mm) quality percentage (%) 63 37.5 31.519 mix design steps 9.5 4.75 2.36 0.6 0.075 95 base ~ 10090 ~ 10060 ~ 7040 ~ 5028 ~ 3816 ~ 288 ~ 152 ~ 6 ~ 10060 ~ 7040 base 10090 ~ 5028 ~ 3816 ~ 288 ~ 152 ~ According to the actual site of the use of aggregate screening results, determine the proportion of aggregate aggregate specifications, aggregate composite gradation should be consistent with table 1-1. The key is to control the throughput of 9.5mm, 4.75mm, and 0.075mm. Take the use of the site of cement, cement aggregate base: =2.5:100, 3:100, 3.5:100, according to the basic aggregate cement: =3:100, 3.5:100, 4:100 of the mixture of vibration compaction, determine the optimum water content and maximum dry density. According to the content and the maximum dry den