主板诊断卡代码速查表(国外英文资料).docVIP

主板诊断卡代码速查表 00 1. by a series of code (excluding 00 and FF) to FF or 00, then the motherboard self-test has passed, OK. 2. out of 00, and the fixed code, then the motherboard does not run, check CPU bad, no, CPU jumper, or CPU settings are correct, no, the power is normal, the motherboard batteries, etc., whether moldy? 3. if you set in the CMOS is not prompt wrong, encounter non fatal fault, diagnosis card will not stop and then go back to the 00 method to change CMOS settings for all errors to boot, if there are non fatal fault is stopped, then according to the code debugging. 01 processor test 1, the processor status is verified, and if the test fails, the loop is infinite. Try changing CPU, check the CPU jumper or CPU settings wrong or not? 02 Determine the type of diagnosis (normal or manufactured). If the keyboard buffer contains data, it will fail. Check the motherboard and keyboard related circuits and the keyboard itself. 03 Clear the 8042 keyboard controller and issue the TEST-KBRD command (AAH). Check the keyboard internal circuit and software. 04 reset the 8042 keyboard controller and verify the TESTKBRD. Check keyboard interface circuit in mainboard. Soft reset / electrifying test of keyboard controller. Circuit for checking keyboard control part in mainboard. 05 8042 of the control states can be obtained if manufacturing tests are repeated from 1 to 5. Check keyboard control circuit in mainboard. Soft reset / energization has been determined. The ROM. is about to start. Check mainboard, ROM chip and its support circuit. 06 make the initial preparation of the circuit chip, disable video, parity, DMA circuit chips, and clear the DMA circuit chip, all page registers and CMOS registers work. Check the circuit associated with the DMA in the motherboard. The ROM is started, the ROM BIOS check sum is checked, and the check for the keyboard buffer is cleared. Check mainboard, RCM chip and its support circuit. 07 processor test 2, verify the work of the CPU regi