正脉冲MWD系统操作流规程.ppt

地面设备包括：接口箱、司显及司显电源、压力传感器、微型打印机、UPS电源、泵压及司显电缆。  接口箱所包含的配件有：串口线2根，并口线2根，一拖二220V电源1根。 司显及司显电源包含有：司显和配套的司显电源。 MWD井下系统组成 正脉冲发生器的工作原理 浅测试 下钻到底后，开泵使用。记录好信号的幅值。开泵时候必须装钻杆滤清器。 填写：上井时的资料，应在返回时基本填写完毕，对仪器的运行记录要填写清楚，返回后只需要填写入库检查等返回测试情况，保留的信号曲线要准确。象运行记录、故障记录、信号曲线等应该在仪器运行一趟钻之后就填写完毕。不能等到返回后再填写。填写时要保持资料的准确、真实。 验收：主岗填写好资料后，由副岗检查，然后找各个部门人员签字，在上交签字前，由本井技术监督进行复审。 1.Metal cleaner and rags only for critical seal areas 2.Geolink provide drawings for all subs and customer manufactures themselves . Make long as possible within geolink dimensions to allow for several recuts. Don’t relieve pin for easy recut 1. Only one screw per clamp bolt or EOR , therefore only one side lines up 2. No loctitie only hand tight but ensure hole clean before install 1. Tighten clamp bolt slightly more to line up castellation with the locking screw , otherwise back off slightly to line up 2. Clamp bolt castellations are offset and only one will line up and one set screw installed 1.Metal cleaner and rags only for critical seal areas 2.Geolink provide drawings for all subs and customer manufactures themselves . Make long as possible within geolink dimensions to allow for several recuts. Don’t relieve pin for easy recut 1. Only one screw per clamp bolt or EOR , therefore only one side lines up 2. No loctitie only hand tight but ensure hole clean before install 1. Tighten clamp bolt slightly more to line up castellation with the locking screw , otherwise back off slightly to line up 2. Clamp bolt castellations are offset and only one will line up and one set screw installed 1. In general for a the start point of a pulse to be detected by the SIB, the drop in pressure must exceed the THRESHOLD level for a period of time greater than the WIDTH LIMIT (default 05 or 0.25 secs). The end point is when the pulse reading goes below the THRESHOLD Level for a period of time greater than the WIDTH LIMIT. The WIDTH of the detected pulse is equivalent to the total time above the Threshold Level (secon