Red-Flag Linux 6.3 系统下设置无线拨号连接.docVIP

Red-Flag Linux 6.3 系统下设置无线拨号连接 网络上有关Red-Flag Linux 6.3 系统下设置无线拨号连接的文章不是太多，昨晚小弟设置成功，把我的设置过程发表出来，希望对大家有用。 Adsl 拨号连接设置（以无线为例，有线可在图形界面DSL连接里面设置） 准备工作：装好linux，装好无线网卡驱动，并与自己的modern无线连接，通讯正常。 记录好你的宽带拨号连接帐号、密码。 开始：打开终端，输入命令并按照提示设置： root@localhost ~]#adsl-setup *在终端输入adsl设置命令 Welcome to the ADSL client setup. First, I will run some checks on your system to make sure the PPPoE client is installed properly... LOGIN NAME Enter your Login Name (default root): username *输入你的宽带拨号连接的帐号， INTERFACE Enter the Ethernet interface connected to the ADSL modem For Solaris, this is likely to be something like /dev/hme0. For Linux, it will be ethX, where X is a number. (default eth0): wlan0 *这是设置拨号的连接接口，默认为第一网卡，0－n依次类推，一般是有线连接用的；这里设置的是无限连接，默认为wlan0，0－n，依次类推。＊＊问题的关键是在这里，只要设置好了这个，下面应该没有问题，一般来说系统的网卡都为eth0－n，但是无线连接成功后linux默认应该成了外网，所以成了wlan0－n；大家可以通过网络连接－连接信息里面的项目查看无线连接的接口，就是接口：以太网（）括号里面显示的内容。 Do you want the link to come up on demand, or stay up continuously? If you want it to come up on demand, enter the idle time in seconds after which the link should be dropped. If you want the link to stay up permanently, enter no (two letters, lower-case.) NOTE: Demand-activated links do not interact well with dynamic IP addresses. You may have some problems with demand-activated links. Enter the demand value (default no): *英文不好，没看懂，意思应该是在需要的时候连接，直接回车，默认no Please enter the IP address of your ISPs primary DNS server. If your ISP claims that the server will provide dynamic DNS addresses, enter server (all lower-case) here. If you just press enter, I will assume you know what you are doing and not modify your DNS setup. Enter the DNS information here: server *DNS设置，输入server系统自动搜索 PASSWORD Please enter your Password: *输入你宽带拨号的密码 Please re-enter your Password: *确认宽带拨号密码，上面的密码重新输入一次 USERCTRL Please enter yes (three letters, lower-case.) if you want to allow normal user to start or stop DSL connection (default yes): *是否允许普通用户使用，默认yes FIREWALLING Please choose the firewall rules to use. Note tha