少数粒子系厳密计算.PPT

* * * * * * * * * * * * * * * * * * * * * * * * * * * * 肥山 * * R * * * * * * * * * * Outline * * * * * When a Λ particle is added to this nucleus, due to spin-spin interaction between Λ and nucleon, we have 0+ and 1+ state. Now, I focus on 0+ state. * They fixed the strength of three-body force to be -30 MeV. And they used four different range of three-body potential like this. If we use this parameter, the calculated energy and width of ground state of 5H is good agreement with the center value of the experimental data. As increasing the this range, the calculated energy become lower and width become narrower. * * * 6H Λ Then, I think that t+n+n+Λ　4-body model is good model to describe 6H. Then. I take t+Λ+n+n 4-body model. Λ t Λ n n t Λ n n 5H Before doing the full 4-body calculation, it is important and necessary to reproduce the observed binding energies of all the sets of subsystems in 6H. Λ Namely, all the potential parameters are needed to adjust the energies of the 2- and 3-body subsystems. t n n Λ 6H Λ 6H Λ 6H Λ t n n Λ t n n Λ t n n Λ 6H Λ I take the Λｔ potential to reproduce the binding energies of 0+ and 1+ states of 4H. In this case, ΛN－ΣN coupling is renormarized into the ΛN interaction. Λ 6H Λ t n n Λ I take the ΛＮ potential to reproduce the binding energy of 3H. Λ Λ t+n+n 1/2+ 6H Λ 5H 1.7±0.3 MeV Γ=1.9±0.4 MeV ? EXP 1.69 MeV Γ= 2.44 MeV ? CAL 0+ 1+ Λ σn?σΛ I focus on the 0+ state. Λ t n n Then, what is the binding energy of 6H? t+n+n 0 MeV ?+ 1.69 MeV Γ= 2.44 MeV Γ= 0.91 MeV 1.17 MeV 4H+n+n Λ E=-0.87 MeV 0+ Exp: 1.7 ±0.3 MeV Even if the potential parameters were tuned so as to reproduce the lowest value of the Exp. , E=1.4 MeV, Γ=1.5 MeV, we do not obtain any bound state of 6H. Λ -　2.0 4H+n+n Λ -2.07 MeV 0+ On the contrary, if we tune the potentials to have a bound state in 6H, then what is the energy and width of 5H? t+n+n+Λ Γ=0.23 MeV Γ=1.9 ±0.4 MeV Λ t n n Λ 6H Λ Then, I use t+n+n+Λ　4-bod