中频炉维修（Medium frequency furnace maintenance）.docVIP

中频炉维修（Medium frequency furnace maintenance） In general, the failure of the intermediate frequency furnace can be divided into two categories which cannot be started and started after failure. As a general principle, when a failure occurs, the entire system should be comprehensively inspected in the event of a power failure. It includes the following aspects: (1) power supply: use a multimeter to measure whether the main circuit switch (contactor) and control of the fuse have electricity, which will eliminate the possibility that these elements will be broken. Rectifier: the rectifier adopts a three-phase fully controlled bridge rectifier circuit, which consists of six fast fuse, six thyristor, six pulse transformer, and a continuation diode. On quick fuse has a red indicator, indicator when normal shrinkage in the shell, when burning of fuse break it will pop up, some of the fast fuse indicator is tight, when the fuse to burn, it get stuck inside, so, to be reliable, can use a multimeter discontinuity measure of fuse, to determine whether it burn out. Simple method of thyristor is measured in multimeter electric block (200 Ω block), measure the cathode, anode, the gate, the cathode resistor, when measuring the thyristor not down. Under normal circumstances, should be infinite resistance between the anode, cathode and gate - cathode resistor should be between 10 to 50 Ω, too big or too small that the thyristor gate failure, it will not be able to trigger conduction. Pulse transformer time butt on thyristor, the original edge on the main control board, with the multimeter to measure the original resistance of about 50 Ω. The continuous diode is generally not easy to fail, and the test is used to detect the second end with a multimeter diode. The current multimeter shows the pressure drop of about 500mV, which is backward. (3) inverter: the inverter consists of four fast thyristor and four pulse transformer, which can be checked as described above. (4) transformer: eac