初入结构工程（Initial structural engineering）.docVIP

初入结构工程（Initial structural engineering） The structure was designed from scratch ? ?? ?? ?? ?? ?? ?? ? A = M/h (gamma f) gamma tend to approximate beam is 0.875, take on board the approximate 0.9 M for column bottom bending moment of beam need to balance the retainer in the vertical load on the beam produced by the combination of bending moment design value being based delta bar strip foundation can be divided into three categories: strip foundation under wall, strip foundation, concrete wall between pillars - column under mixed strip footing (generally used for frame shear wall structure) (1) strip foundation under wall delta calculation of soleplate section shear bearing capacity, determine the thickness of soleplate is strip foundation design delta alone when the plinth is close to the main points of the square two-way slabs, need check blunt shear; The strip foundation is a long strip member of unidirectional force, and the shear force needs to be checked. Delta bar under the foundation slab width = delta wall foundation in foundation slab beam delta concealment does not need to set up the root of the foundation slab thickness by hand to determine: (1) the precise: bottom root thickness, controlled by the shear plain concrete section V 0.7 or less * beta * * b * h f (2) empirical estimates: take a base (net) and a half wide under 1/6 ~ 1/4 delta wall foundation reinforcement of simplified algorithm: reinforcement mainly consider the influence of the bending? ? The largest section of the bending moment is the bending moment of the root section of the base plate. ? After the moment of bending moment, can we find the reinforcement by the following formula? ?? ?? ????? A = M/h (0.9 f)? ? The provisions of the rules of each linear meter distribution reinforced area of not less than 1/10 of the reinforced area of delta as a broad base base is equal to 2500 mm, in order to save, reinforced length is 0.9 times of the width of the general take, staggered, isolated foundati