屋面合成高分子卷材（Roofing synthetic polymers）.docVIP

屋面合成高分子卷材（Roofing synthetic polymers） Construction technology standard of polymer waterproof rolling materials for roofing 1. Scope of application The technical standard is applicable to the construction of the construction of the construction of the construction of the construction of the construction of waterproof rolling materials of polymer waterproof rolling. 2. Construction preparation 2.1 materials and requirements 2.1.1 synthetic high polymer rolling materials 2.1.1.1 tri-propyl-butyl rubber waterproof rolling material Specification: thickness 1.2mm, 1.5mm, long 20m, width 1m; 2.1.1.2 chlorinated polyethylene - rubber combined waterproof coil Specification: 1.2mm, 1.5mm, 20m, 1m, 2m; 2.1.1.3 chlorinated polyethylene waterproof rolling material Specification: 1.2mm thick, 20m long and 0.9 m wide; 2.1.1.4 technical performance: Note: class I is the high performance plastic body coil. Ⅱ class for ordinary plastic body coil 2.1.2 appearance inspection The coil surface should be smooth, no cavity, crack, wrinkle, and other defects that affect water permeability. Crease: no more than 2 parts per volume, no more than 20mm in total length; Impurities: no more than 0.5mm grain; Glue block: no more than 6 parts per volume, each area is not more than 4mm2; Lack of glue: no more than 6 parts per roll, no more than 7mm per volume, not more than 30% of its thickness. Storage, transportation. 2.1.3.1 store in a cool and ventilated room, avoid rain, sun and moisture, and keep out of the fire. 2.1.3.2 coil shall be stacked in an upright position and shall not be more than two storeys high. Two layers shall be deposited or transported between the two layers for a fiberboard or plywood. Short distance transportation should not exceed 4 floors. 2.1.3.3 avoid contact with hazardous substances such as chemical media and organic solvents. 2.1.4 auxiliary materials 2.1.4.1 synthetic polymer waterproof rolling material supporting materials 2.1.4.2 modified asphalt waterproof coating