汽轮机3（The steam turbine 3）.docVIP

汽轮机3（The steam turbine 3） 1. Fill in the blanks: : 0.2 points, 20 points in total 1. The variable pressure operation refers to maintain the steam turbine inlet steam valves (full open) or in an opening (), when the boiler steam temperature (rating), change the steam (pressure), so as to adapt to the unit load demand for (steam flow). 2. Improve the unit (initial parameters) and reduce the unit (final parameters) to improve the economy of the unit. C) F l + Y % d U: t3. When the turbine speed exceeds (3090) RPN, the OPC solenoid valve operation group is turned off (regulating the valve). When steam turbine speed more than (3270), AST, electromagnetic valve, group action closure (main valve and regulating valve) machine stop, when steam turbine speed more than rated speed (110-112) % when emergency action and machine stop. . | : P/o. F $C9 J7 o d * g (V4. Vacuum leak test should be in load stability above (80%) rated load, vacuum is not lower than the Kpa (90-85). Under the condition of average vacuum decline in value is not more than a minute (400 pa) for qualified. 5. The leakage of the high pressure heater pipe is the heater water level (raise), the water supply temperature (decrease), the steam side pressure (raise), the steam side security door movement. 6. On the one hand, the heat from the steam turbine is used to improve the heat of the water supply, while reducing the heat loss in the steam (condenser). 1 J h + k A) s * W7. During the vacuum tightness test, the vacuum drop rate ( = 0.13kpa/min) is excellent, ( = 0.27 kpa/min). 1 H6 j * K/U + H n * N: q is good, ( = 0.4 kpa/min) is qualified. 8. The power of a given pump motor is (3200) kilowatts, because its recirculation door is not strict, and the running medium increases the current to 10A, which consumes approximately (80-90) per hour, kw. H. 9. At the current operation of the four units, the highest temperature of the radiator is the (# 4) machine, which is more efficient than other units (lowest). 8