三板式二级推出方仪器盒注塑模.pdf

塑机与模具 文章编号： （ ） 1005-3360 2011 12-0074-03 闫闵 Yan Min - 青岛工学院，山东胶州 266300 - Qingdao Institute of Technology, Jiaozhou 266300, China 摘　要 : 论述了方仪器盒注塑模的模具结构特点和工作原理。该模具一模一腔，二次分型，中心点浇口进料，推件板- 弹簧二级推出塑件。模具动作可靠，推出效果好，可实现全自动操作。 Abstract : The mould structural features and operational principle for square instrument box were discussed. One mould cavity and twice cavity parting was adopted on the mould with central pin-point gate. The stripper plate and spring mechanism came into effect in two stages ejection. The mould is reliable in operation, good for ejection effect, and the fully automatic operation can be realized. 关键词 : 方仪器盒；二次分型；二级推出；点浇口；注塑模 中图分类号 : TQ320.52 文献标识码 : A Key words : Square instrument box; Twice cavity parting; Two stages ejection; Pin-point gate; Injection mould 模具结构如图 所示。该模具采用一模一腔， 2 三板式，中心点浇口进浇，推件板 弹簧二级推出机 - 方仪器盒塑件如图 所示。材料为 ，为无 构。具体如下： 1 ABS 定形塑料，模具设计时要注意浇注系统，选择好进 （）弹簧分型限位板定距二次分型机构 由限 1 料口位置、形式；推出力过大