MAX1232（MAX1232）.docVIP

MAX1232（MAX1232） Max1232 Chinese data reward points: 10 | question time: 2007-6-22 15:02 | questionger: ouou007 | why is closed Max1232 (watchdog) Chinese data There are 1 other answers As an important means to improve the system reliability, hardware monitoring chip has been widely used in the application system design of single chip microcomputer and digital signal processor (DSP). For a certain microcontroller application experience of the design staff, in the beginning of the DSP system design, often based on experience in the use of single-chip microcomputer system commonly used monitoring chip, such as MAX706, MAX1232 and so on. However, since DSP itself is different from the characteristics of SCM, especially in the case of real-time requirements, it is inappropriate to completely copy the experience of using monitoring chip in single-chip microcomputer system. The combined use of TI company produced the fixed-point DSP chip TMS320F206 (F206) in the electric power fault recorder design experience filter, a detailed discussion of DSP system hardware monitor chip selection, the impact of system operation in real time and need to pay attention to. 1 DSP reset features and requirements for monitoring chip Before the discussion, it is necessary to briefly describe the reset features of F206. For F206, a reset is an optional external interrupt (interrupt vector address 0000H) that is available at any time and puts F206 in a known state. A reset is the highest priority interrupt, usually reset when the chip is in unknown state after power up. Because the reset signal halts the memory operation and initializes the hardware status bits, the system should rerun the initialization program after each reset. In the strict sense, the F206s reset source is only 1, namely the reset pin RS produces 1 low level pulse signals, causes the chip to reset. In order for the system to work correctly after power up, the active low time of the RS terminal needs at least 6 clock cycles.