高空作业施工方案（High altitude work construction scheme）.docVIP

高空作业施工方案（High altitude work construction scheme） The wall is a vertical component of the building, but the design, construction, material, use and other factors can cause cracks in the wall, causing leakage. The method for the treatment of the wall is to repair the waterproofing of the original structure, and its function is to disperse the water. When the cavity construction is partial damage, it is better to use restorative repair. Repair with waterproof material: this method can be used widely, that is, the water seeping into the indoor part adopts the oil solution or the water-proof waterproof material, the sealing or painting method. Waterproof measures are taken on the outside of the wall panel. The wall is covered with water: the waterproof material is adopted in the side part of the external wall, and the rainwater is blocked by waterproof material. The companys construction strength of high altitude operation, to all kinds of waterproof and repair works have professional technicians to the site to survey, divide, and develop the construction plan. Therefore, it is not necessary to set up scaffolding for the high - rise wall water leakage. Second, the metope of architectural coatings construction: new metope paint construction: the ground floor of the building exterior wall coating requirements enough curing period, the new water slurry concrete surface must pass a reasonable maintenance time, let the base vomit, fully dry. The underlying surface should be dry, firm and firm, and should not be defective, such as sand, crack and loose. Construction method: the exterior wall coating is not suitable for the large area batch to scrape putty, the putty layer should not be too thick, the material USES polymer cement putty. It is usually applied to the base coat, and it is applied twice. According to the engineering quality requirement, the surface can be added to the surface. The coating construction is usually carried out from top to bottom, and each brush should