网络端口配置NAPT.docVIP

?R1: Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#host R1 R1(config)#int fa0/0 R1(config-if)#ip add 192.168.1.1 255.255.255.0 R1(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up R1(config-if)#exit R1(config)#int s2/0 R1(config-if)#ip add 200.1.1.1 255.255.255.0 R1(config-if)#no shut %LINK-5-CHANGED: Interface Serial2/0, changed state to down R1(config-if)#clock rate 64000 R1(config-if)#exit R1(config)# R1(config)# R1(config)# R1(config)# %LINK-5-CHANGED: Interface Serial2/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial2/0, changed state to up R1(config)# R1(config)#ip route 200.1.2.0 255.255.255.0 200.1.1.2 //配置静态路由 R1(config)#end R1# %SYS-5-CONFIG_I: Configured from console by console R1#show ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set C 192.168.1.0/24 is directly connected, FastEthernet0/0 C 200.1.1.0/24 is directly connected, Serial2/0 S 200.1.2.0/24 [1/0] via 200.1.1.2 R1# R1# R1#conf t Enter configuration commands, one per line. End with CNTL/Z. R1(config)#int fa0/0 R1(config-if)#ip nat inside R1(config-if)#exit R1(config)#int s2/0 R1(config-if)#ip nat outside R1(config-if)#exit R1(config)#access-list ? 1-99 IP standard access list 100-199 IP extended access list R1(config)#access-list 1 ? deny Specify packets to reject permit Specify packets t