电路引用partial discharge detection for GIS a comparison between UHF and acoustic methods.pdfVIP

Partial Discharge Detection for GIS: A Comparison between UHF and Acoustic Methods Bo Qi, Chengrong LI, Zhen HAO, Bibo GENG Dangguo XU, Shaoyu LIU, Chun DENG Beijing Key Laboratory of High Voltage EMC North China Electric Power Research Institute North China Electric Power University Beijing, China Beijing, China lqicb@163.com Abstract— The widespread application of SF6 gas insulated instance, has got standard detection circuit, calibration substations (GIS) in high voltage power transmission requires reliable measurement and test procedures under the guidance of IEC fault detection and diagnosis techniques. Partial discharge (PD) 60270. It can easily capture the apparent discharge magnitude. detection has so far been proven to be the most effective tool for GIS Yet, it cannot perform on-line detection for it requires long test insulation diagnosis. Both ultra high frequency (UHF) technique and duration and has poor anti-interference performance, and low acoustic means have been popularly used in PD detection thanks to signal-to-noise ratio. The UHF method has proven to be well their well-noted anti-interference performance. In spite of numerous capable of avoiding the surrounding electromagnetic researches on either UHF or acoustic techniques, little has been done interference in real operation. In addition to the good anti- to draw a comparison between the two. To address this research gap,