光钎接口（Light soldering interface）.doc

光钎接口（Light soldering interface） SC stands for Standard Connector ST stands for Straight Tip FC stands for Fiber Connector Fc sc st is three types of fiber optic connections, representing different interface structures. Fc (ferrule connector) is a metal socket screw structure. Sc is developed by NTT co., LTD., which is a rectangular plastic casing joint. The sc refers to the square mouth, and the st refers to the round mouth What do you mean by the type of fiber jumper FC, SC, ST, MU, LC, MTRJ? A fiber optic is a medium that transmits a message from one end to the other. It is a glass or plastic fiber that ACTS as a medium for sending messages through. Usually fiber and cable two nouns can be confusing. Most of the fiber before use must be covered by several layers of protection structure, cable after coating is called the cable. Optical fiber outer protection structure can prevent the environment to the damage of the fiber, water, fire, electric shock, etc. The cable is divided into: optical fiber, and only the buffer layer. Optical fiber and coaxial cable are similar, but no mesh shielding layer. The center is the glass core of light transmission. In multimode fiber, the diameter of the core is 15mm ~ 50mm, roughly equal to the thickness of human hair. The diameter of single mode fiber core is 8mm ~ 10mm. The core is surrounded by a glass envelope with a lower refractive index than the core to keep the fiber in the core. Outside is a thin plastic coat to protect the envelope. The fibers are usually bunched and protected outside. The core is usually a small double-concentric cylinder made of quartz glass, which is brittle and brittle, so it needs a protective layer. Characteristics of optical fiber Due to the optical fiber is a kind of transmission medium, it can be like copper cable, transmit data such as phone calls or computer data, the difference is that fiber rather than the electrical signal is transmitted light signals. Therefore, optical fiber has many uniqu