剖腹产资料（Cesarean section）.docVIP

剖腹产资料（Cesarean section） 1. Open the abdomen 2. Open the amniotic membrane 3. The babys head leaves the matrix The shoulder leaves the matrix, and can see the cord around the neck The baby is completely isolated 6. Disinfect the cord of the babys umbilical cord 7. Suture amniotic membrane and abdomen and disinfection -- -- -- Open the abdominal wall in the middle line, the middle line and the symphysis of the pubic bone (FIG. 1). The size of the incision should be based on full exposure of the lower part of the uterus and the successful delivery of the fetus. 2. Probe abdominal exploration under the direction of rotation and degree, uterine segment formation condition, fetal head size, presentation, to estimate the location and size of uterine incision, operation easy and ready to make corresponding measures, after probing respectively in the corpus and fill in the brine ShaDian between abdominal wall on both sides, to opened the intestinal canal and prevent the amniotic fluid and blood into the abdominal cavity. 3. Cut reflected bladder peritoneum From the uterus bladder peritoneum return reflected peritoneal fold 2 cm place forceps, then cut a small mouth, arc extended to 10 ~ 12 cm to each side (figure 2), on each side of the inside round ligament. 4. Under the separation of the bladder Rat teeth clamp will lower uterine segment reflected the free edge near the bladder peritoneum incision, blunt performer in the left hand index finger and middle finger after bladder wall isolation and goes down in the lower uterine segment (figure 3), the lower uterine segment fully exposed. If the bladder is obvious, the anterior fascia of the cervix can be sheared off and pushed off the bladder in the fascia to reduce bleeding. 5. Open the uterus The incision height is determined according to the height of the fetal head, usually the maximum diameter of the head diameter of the fetal head is the most turgable part of the lower segment. It should be low for the deep inlay of the