nrf51822学习笔记之GPIO.docxVIP

GPIO手册介绍：共有32个GPIO参数The following parameters can be configuredthrough these registers:? Direction? Drive strength? Enabling of pull-up and pull-down resistors? Pin sensing? Input buffer disconnect? Analog input (for selected pins)各寄存器说明（手册）代码实现（示例代码）结构体：the GPIO ports are defined as follows: * - Port 0 - pin 0-7 * - Port 1 - pin 8-15 * - Port 2 - pin 16-23 * - Port 3 - pin 24-31typedef enum{ NRF_GPIO_PORT_DIR_OUTPUT, NRF_GPIO_PORT_DIR_INPUT } nrf_gpio_port_dir_t; //port/** * @enum nrf_gpio_pin_dir_t * Pin direction definitions. */typedef enum{ NRF_GPIO_PIN_DIR_INPUT, NRF_GPIO_PIN_DIR_OUTPUT } nrf_gpio_pin_dir_t; //Dir/** * @enum nrf_gpio_port_select_t * @brief Enumerator used for selecting between port 0 - 3. */typedef enum{ NRF_GPIO_PORT_SELECT_PORT0 = 0,/// Port 0 (GPIO pin 0-7) NRF_GPIO_PORT_SELECT_PORT1, /// Port 1 (GPIO pin 8-15) NRF_GPIO_PORT_SELECT_PORT2, /// Port 2 (GPIO pin 16-23) NRF_GPIO_PORT_SELECT_PORT3, /// Port 3 (GPIO pin 24-31)} nrf_gpio_port_select_t;/** * @enum nrf_gpio_pin_pull_t * @brief Enumerator used for selecting the pin to be pulled down or up at the time of pin configuration */typedef enum{NRF_GPIO_PIN_NOPULL=GPIO_PIN_CNF_PULL_Disabled, NRF_GPIO_PIN_PULLDOWN = GPIO_PIN_CNF_PULL_Pulldown, NRF_GPIO_PIN_PULLUP = GPIO_PIN_CNF_PULL_Pullup, } nrf_gpio_pin_pull_t;/**@enum nrf_gpio_pin_sense_t@brief Enumerator used for selecting the pin to sense high or low level on the pin input. */typedef enum{ NRF_GPIO_PIN_NOSENSE = GPIO_PIN_CNF_SENSE_Disabled, NRF_GPIO_PIN_SENSE_LOW = GPIO_PIN_CNF_SENSE_Low, NRF_GPIO_PIN_SENSE_HIGH = GPIO_PIN_CNF_SENSE_High, } nrf_gpio_pin_sense_t;分解：#define NRF_GPIO ((NRF_GPIO_Type *) NRF_GPIO_BASE)其中：typedef struct { // ! GPIO Structure __I uint32_t RESERVED0[321]; __IO uint32_t OUT; // Write GPIO port.