6ra70常见问题问答（6RA70 FAQ）.docVIP

6ra70常见问题问答（6RA70 FAQ） 1: every brief parking (1 minutes or so), when the start of fast melting burn. After the replacement of insurance, the car does not burn insurance. How do you adjust those parameters?. Answer: (1) suggest modify P159, 160, 161, 179 (2) the problem I have encountered, not the parameter problem, because the parameters did not change if in a short time after parking inside the burning start again the risk of insurance, but by hand no problem, I suspect that the insurance itself has a problem 2: I need to read 6RA70 running current to PLC, which 1 function blocks should I use? 2, what problems should we pay attention to in programming? 3, 6RA70 also need to add what parameters settings? Answer: (1) call USS_RPM_W in S7-200, read K0117 Programming time: EN needs to be enabled; XMT_REQ needs rising edge to trigger; DRIVE is 1; Param is 117, that is, (K0117); Index is 1; DB Ptr is VB600 and cannot conflict with other instructions in the program. Return value arbitrary. 6RA70 does not need to set parameters. (2) between 6RA70 and S7-200 if you exchange parameters by using PZD, you will need 70 said that connection K117 current can be placed on you want the X words, is such an entrance parameters can be 70 3: we are now using 6RA70 to the motor speed, speed is used to encoder feedback, the rated speed of the motor is 1500 rpm, but our process speed is not too fast, the maximum speed can reach 1000, we can limit the maximum speed 1000 only by setting the 6RA70 parameter? Answer: you can set P512=60% or P513=-60% Or set P143=1000 4: we are using the 6RA70 DC governor for motor speed regulation, speed feedback is used in the encoder, but the scene environment is bad, the encoder is easy to damage, and now we want to cancel the code, which parameters should be changed? Answer: (1) p083=3 at this time is the choice of potential feedback, p115 corresponds to the motor potential equivalent to the percentage of the line voltage, such as the line 400V, motor vo