sap2000总结（SAP2000 summary）.docVIP

sap2000总结（SAP2000 summary） 1, load conditions (load, case): the definition of various load types (define), and then by specifying (assign) to establish the model of spatial distribution of force, displacement or other effects (such as: temperature). This is only a function, and the load case itself does not respond to the structure. 2, case (analysis): defining the mode of load (static or dynamic), the response of the structure (linear or nonlinear), analytical methods (modal analysis or direct integration). The analysis conditions include load cases, the analysis case can correspond to a load condition, and can also be a combination of loads (multi-point wind load, multi dimensional ground motion). The response of the structure to the load can be obtained by operating the analysis case. 3, the definition of combination (define combination): is the case calculation results were combined (computer operation to reduce artificial workload calculation), combination of commonly used linear superposition (linear) or envelope (envelope). 1. time history analysis with EL wave, the original records are generally based on the acceleration of gravity wave g as a unit, its peak is 0.341g, which is 0.341*9.8m/s2. and you sap the unit is N/mm/s, is your unit with the original wave unit is 1000*9.8 units, then you should enter the 9800 coefficient. If your SAP unit is N/m/s, then your coefficient is 9.8. The 8 degree rare requirement in the 2. procedure is 400g, which is the abbreviation of unit gal, and its unit is cm/s2, G. Actually, its the 0.4 acceleration of gravity. That is, 400gal = 0.4g, consider first points, then your coefficient should be 1000*9.8* (0.4/0.341) = 11495.6. 3., when the time function is defined, the unit does not matter, as long as your coefficient is good, you can. Note: the seismic function input by SAP is itself without units, and its units go along with the units in the lower right corner of your sap. Thats why you need to compare this unit with the or