skf轴承（Skf轴承）.docVIP

skf轴承（Skf轴承） GS -- the seat ring of cylindrical roller thrust bearings K -- cylindrical roller cage thrust assembly K- - ABMA standard series of Inch Tapered roller bearings, inner ring, roller cage assembly (CONE) or outer ring (CUP) L - the inner or outer ring of a separable bearing R -- the inner or outer ring of the separable bearing is connected to the roller cage assembly W stainless steel deep groove ball bearing WS -- shaft ring of cylindrical roller thrust bearing ZE - Bearings for electrical control installation Suffix： A - internal design that has been improved or changed slightly. Having the same dimensions, they usually have different meanings for different types or series of bearings. For example: 4210A- double row deep groove ball bearings without ball gap; double row angular contact ball bearings with 3220A- contact angle of 30 degrees AC -- single row angular contact ball bearings with contact angles of 25 degrees ADA - the retaining grooves on the outer ring are improved, and the inner rings of the segments are fixed by a fixed ring B - internal design that has been improved or changed slightly. Having the same dimensions, they usually have different meanings for different types or series of bearings. For example: 7224B- contact angle of 40 degrees single row angular contact ball bearings; 32210B- contact angle larger cone roller bearings Bxx (x) -- B is combined with a two or three digit number to indicate variants that do not have proper suffixes. Such as B20- narrowing of Width Tolerances C - internal design that has been improved or changed slightly. Having the same dimensions, they usually have different meanings for different types or series of bearings. For example: 21306C- spherical roller bearings, with two window shaped steel cage, inner ring without edge and with a guide ring guided by inner ring CA - 1.C spherical roller bearings, with fork type machined brass holder, inner ring with sides at the side and with a guide ring guided by the