结构设计说明（Structural design specification）.docVIP

结构设计说明（Structural design specification） 1. structural design notes Design is mainly based on seismic grade, levels of civil air defense, and the bearing capacity of the foundation, moisture-proof, the value of live load, material grade, matters needing attention in the construction with details, general details or nodes, as well as in the construction not shown in the figure to express through that information. For example, cement mortar shall be used under zero plus or minus, and mixed mortar shall be adopted. Wait。 2. the structural layout of each floor, including: (1). The precast slab layout (plate selection, slab size and reinforcement). Mark number and type of the precast slab, do not use diagonal form. Because this method is easy to cause the crossing of the line, the horizontal or vertical lines should be adopted, and the type of room should be marked directly with the same type of room. Should be unified number of the whole floor, can reduce the design workload, but also facilitate the construction staff to look at. As far as the seam 40, the seam unworthy of the muscle or with a rib. The room layout from the inside out, as far as possible the use of wide plate slab with in the window, the best bandwidth of more than 200 cast-in-place slab (considering the riser wear plate plumbing). If the entire water layer construction requirements, seams should be greater than 60. The overall casting thickness is 50, with two-way phi 6@250, concrete C20. Should adopt the horizontal wall or horizontal vertical wall (transverse wall as the main) mixed bearing program, good resistance to collapse. Prefabricated slabs shall not be allowed at constructional poles. Recommend the use of artificial PMCAD layout function cloth panels, automatic layout may not meet the requirements of the construction plans, can only meet the requirements of load transfer route definition. Very sensitive to the floor clear height, over a span of 6.9 meters or not in line with the modulus can be u