金属转子流量计（Metal rotor flowmeter）.docVIP

金属转子流量计（Metal rotor flowmeter） I am a flowmeter, the following is my company rotor flow failure analysis summary Pointer jitter: 1. slight pointer jitter: usually due to medium fluctuations. It can be overcome by adding damping. 2. moderate pointer jitter: usually due to medium flow state caused. For gas, usually due to unstable media operation pressure. A steady or steady flow device can be used to overcome or increase the air damping of the float flowmeter. 3. pointer jitter: mainly due to severe pulsating gas pressure instability, operating state or the user is given the pressure, temperature, flow rate and the actual state of the rotameter is inconsistent, there are large differences caused by excessive rotameter. Two 、 the pointer stops at a certain position The main reason is that the float of the float meter is jammed. Generally, when the float meter is used, the valve is opened too quickly, so that the floater rapidly impacts the stopper, causing the stopper to deform and float the plug. But it does not rule out that the float is jammed due to the misalignment between the float guide bar and the stop ring. Treatment can be removed meter deformation stopper remove plastic, and check with the guide rod is concentric, concentric can be corrected if not, then the float installed, hand feeling under the float, float on unimpeded card, in addition, the flowmeter must be installed vertically or horizontally. The installation can not tilt, otherwise it is easy to cause the card table and bring error to the measurement. Three, large measurement error 1. the installation does not meet the requirements For vertical mounting, the float shall be vertical, with a tilt angle no greater than 20 degrees For horizontal mounting floater, keep the level of the angle of no more than 20 degrees There shall be no ferromagnetic object in the 100mm space around the float. The installation position shall be away from the valve orifice, pump outlet, process line, turning port and so o