热工知识（Thermal engineering knowledge）.docVIP

热工知识（Thermal engineering knowledge） Fill in the blanks 1, regardless of the simple instrument or the complex instrument, its components may regard as the function by the sensor and the converter and the display device three links, between them uses the signal, the line or the signal pipeline connection. 2. The industrial thermal resistance is composed of five parts, such as temperature sensing element, insulating tube, inner lead wire, protective sleeve and junction box. 3, industrial hot spot resistance is platinum resistance, copper resistance, nickel resistance three kinds. 4 when installing the pressure gauge, the selection of sampling points should be representative, and the measuring point can not be installed in the place where there is eddy current. 5, the industrial pressure meter accuracy class has 1, 1.5, 2.5, three kinds 6. The zero shift of the pressure transmitter is to transfer the measured parameter corresponding to the zero point of the transmitter to zero. 7, when measuring the fluctuation pressure, the pressure gauge shall be equipped with damping device. Two, multiple-choice questions: 1. There is a pressure measuring point. If the maximum pressure is measured 10MPa, the range of the selected pressure gauge should be (A). A, 16MPa, B, 10MPa, C, 25Mpa, D, 20MPa. Use range 2, pressure gauge in 1/32/3 its range, if less than 1/3 (C). A, accuracy class drops; B, because the pressure is too low to indicate; C and relative error increase, D and random error increase. 3. The indication of the pressure gauge in the industrial field indicates the measured parameter (C). A, dynamic pressure, B, total pressure, C, static pressure, D, absolute pressure. 4, the quality of thermal instrumentation is usually used (B) and other three main indicators. A, sensitivity, stability, time delay, B, accuracy, sensitivity, time delay; C, stability, accuracy, rapidity, D, accuracy, stability, time lag. 5. The electric contact pressure meter is used (D). A, measure instant