维修讲义。（Maintenance handouts.）.docVIP

维修讲义。（Maintenance handouts.） Maintenance handouts 1: Machinery: crossbeam, leg, tail plate, partition plate, compression plate, cylinder seat. Pipe, valve, trachea road three, material line three. The function and interlock of each valve. Two: Hydraulic; this is the power part of the machine, power source, mainly is the whole machine pressing and releasing, when pressed, to ensure the sealing of the filter plate, loosen the pressure of the whole machine, is the first to prepare the discharge One action. It is divided into two parts 1; hydraulic station assembly 2; cylinder assembly 1; hydraulic station assembly: tank; function; storage of hydraulic oil; the side has an oil level mark; it and the tank are added together Oil position when there is a display of oil level, oil level can not be at the end of the oil mark shows 60% (there is a requirement must be pressing plate in the position of the back limit), if the oil changes, to be replaced as a whole, oil All the oil in the tank is replaced. After replacing the hydraulic oil, a part of the oil is injected into the cylinder. The oil will be stored in the tank, and the oil in the tank will decrease accordingly And then add a hydraulic oil to ensure that no less than 60% of the oil mark position (additional overtime requirements and the above requirements), the oil pump plug variable pump, pump oil and lifting pressure valve seat fixed valve. The block (one-way valve, solenoid valve, overflow valve, electromagnetic ball valve, superimposed pressure reducing valve) one-way valve: is a pressure maintaining role. It is a positive filter press. It stays motionless after pressing The pressure in the state is the pressure of the rear cavity of the cylinder. {solenoid valve}: the solenoid valve solenoid valve after the electric power through to attract the spool to change the direction of flow There is no reversal of the motor, are clockwise movement, electromagnetic valve is to change the direction of the flow of oil flow,