推挽输出、开漏输出、复用开漏输出、复用推挽输出以及上拉输入、下拉输入、浮空输入、模拟输入区别（Push-pull output, drain output, multiplexed output, push-pull output, and upper pull input, dropdown input, floating null input, analog input differences）.docVIP

推挽输出、开漏输出、复用开漏输出、复用推挽输出以及上拉输入、下拉输入、浮空输入、模拟输入区别（Push-pull output, drain output, multiplexed output, push-pull output, and upper pull input, dropdown input, floating null input, analog input differences） The difference between push-pull output, drain output, multiplexed output, push-pull output, and upper pull input, pull-down input, floating air input, and analog input The output of push-pull output, leakage output, the reuse of the drain output, and the reuse push-pull output And the difference between the input, the dropdown input, the dummy input, and the analog input When looking at the data manual recently, there were eight different types of GPIO configurations in cortex-m3: (1) GPIO_Mode_AIN simulate input (2) GPIO_Mode_IN_FLOATING empty input (3) GPIO_Mode_IPD drop-down input (4) pull input on GPIO_Mode_IPU (5) GPIO_Mode_Out_OD opens the output (6) GPIO_Mode_Out_PP push-pull output (7) GPIO_Mode_AF_OD is used to reuse the output (8) GPIO_Mode_AF_PP reuse push-pull output For beginner novice, I think this a few concepts is must be clear, contact most at ordinary times is the push-pull output, open drain output, the input of the three, but havent done induction to these. So heres a summary: Push-pull output: can output high, low level, connect digital devices; The push-pull structure is generally referred to as the two triode signals controlled by two complementary signals, and the other ends when a triode is connected. The low and low level is determined by the power of IC. Push-pull circuit are the two parameters are the same triode or MOSFET, push-pull way is present in the circuit, the waveform is responsible for the positive and negative half cycle of amplification, the circuit work, two symmetrical power switch tube each time only one conduction, so small conduction loss and high efficiency. The output can either feed the current to the load or extract the current from the load. The push-pull output level increases the load capacity of the circuit and the